5.5) Installing the wire in the Brake Hub
The hub is adjusted when delivered, if readjustment is required, follow the instructions below. Adjust the
brake hub so that wire is slightly slack when wire feed stops.
Adjusting the braking torque:
¡
Turn the red handle to the locked position.
¡
Insert a screwdriver into the springs in the hub.
¡
Turn the springs clockwise to reduce the braking torque.
¡
Turn the springs counterclockwise to increase the braking torque.
NOTA: In order to latch or unlatch, just turn the red handle. There´s no need to
5.6) Lifting
To move the feeder around the workplace use a hook, use the lifting eye for lifting, P/N.: 0401231 according
to the picture below.
30
Picture 1
N.B.: Turn both springs through the same amount.
remove it.
Picture 2