Rear Panel - ESAB Origo Feed 304 P2 Manual De Instrucciones

6) 2/4 Stroke - With 2 stroke
released.
With 4 stroke , the gas flow starts when the trigger switch is pressed in and the wire feed starts when it is
released. The welding process continues until the switch is pressed in again, the wire feed stops and
when the switch is released the gas stops flowing.
7) Interruptor of manual wire release - Allows the wire to be fed without voltage in the welding gun.

4.3) Rear panel

8) Connection for welding current from power source.
9) Connection for control cable from power source.
10) Connection for shielding gas.
11) Brake Hub.
12) Inlet Nozzle.
3
4
, wire feed starts when the trigger switch is pressed in and ends when it is
2
1
9
10
8
7
6
5
11
12
25