ESAB Origo Feed 304 P2 Manual De Instrucciones página 29

To use wire with over 1.6 mm use feed rollers of the Table 5.3 and 5.4 using feed rollers and guides on the
top part.(Table 5.3)
TABLE 5.1
Diameter Type
0.6 / 0.8 Fe, Ss,C
0.8 / 0.9 - 1.0 Fe, Ss,C
0.9 - 1.0 / 1.2 Fe, Ss,C
1.4 / 1.6 Fe, Ss,C
0.9 - 1.0 / 1.2
1.2 / 1.2
1.2 / 1.4
1.6
0.8 / 0.9 - 1.0
1.2 / 1.6
C = Cored wire
K = Knurled
TABLE 5.2
Description
Feed roller and nozzle for aluminium 0.8/1.0
Feed roller and nozzle for aluminium 1.2/1.6
TABLE 5.3
Wire type
Pressure feed roller
Cored wire
TABLE 5.4
Wire diameter (mm)
Inlet nozzle
Intermediate nozzle for Fe, Ss, C
Outlet nozzle for Fe, Ss, C
5.4) Wire feed pressure
Start by making sure that the wire moves smoothly through the wire guide.Then set the pressure of the wire
feeder's pressure rollers. It is important that the pressure is not too great.
To check that the feed pressure is set correctly, you can feed out the wire against an insolated object, e.g. a
piece of wood.
When you hold the gun approx. 5 mm from the piece of wood (pic.1) the feed rollers should slip.
If you hold the gun approx. 50 mm from the piece of wood, the wire should be fed out and bend (pic.2).
Part Inlet
Number Nozzle
0707810 0707157
0707811 0707157
0707812 0707157
0707813 0707157
C 0707814 0707157
C 0712720 0707157
C 0707815 0707157
C 0707816 0707157
AL 0707817 0707157
AL 0707818 0707157
Reference
0401240
0401241
Diameter (mm)
2.80 - 3.20
1,60 - 3,20
0901094
0900896
0905498
Output
Intermediate
Nozzle
Nozzle
0707821 0707605
0707821 0707605
0707821
0707605
0707821 0707605
0707821 0707605
0707821 0707605
0707821 0707605
0707821 0707605
0707158 0707896
0707158 0707896
-
2.40
Type Identification
V 0.6 S2 & 0.8 S2
V 0.8 S2 & 1.0 S2
V 1.0 S2 & 1.2 S2
V 1.4 S2 & 1.6 S2
V - K 1.0 R2 & 1.2 R2
V - K 1.2 R2 & 1.2 R2
V - K 1.2 R2 & 1.4 R2
V - K 1.6 R2
U 0.8 A2 & 1.0 A2
U 1.2 A2 & 1.6 A2
Reference
0900467
0901204
0902230
29