ASSEMBLY INSTRUCTIONS
13. Secure the grill body (O) using two M6x20
screws (EE) on each side.
Hardware Used
EE
M6x20 Screw
14. Install the natural gas hose holders (Z) by
removing four M4x10 screws (DD) from the
predrilled holes in the bottom shelf (A), aligning
the natural gas hose holders (Z) with the
predrilled holes and over the natural gas hose,
then securing with the screws (DD).
Hardware Used
DD
M4x10 Screw
15. Partially insert two M6x16 screws (FF) into the
left side of grill body (O). DO NOT fully tighten
screws (leave approximately 5 mm).
Hardware Used
FF
M6x16 Screw
13
x 4
1
14
1
x 4
15
1
O
x 2
12
O
1
1
Z
DD
1
FF
1
EE
1