Dyna-Glo DGA550SSN Manual De Instrucciones página 16

ASSEMBLY INSTRUCTIONS
24. Insert the warming rack (W) into the two holes
located on the back edge of the grill body (O).
25. Insert the grease pan (S) into position by sliding it
in the grill body (O) from the rear along the rails.
Insert the grease cup (T) into position by sliding
it onto the rails located on the bottom side of the
grease pan (S).
26. Remove the igniter cap by turning it counter-
clockwise. Insert the AA battery (L) into the igniter
body with positive (+) end facing out. Replace the
igniter cap.
24
25
26
L
16
W
O
T
S