Dyna-Glo DGA550SSN Manual De Instrucciones página 18

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
Checking for Leaks
After all connections are made, check all connections and fittings on the NG hose and quick
connector for leaks with a water and soap solution.
To prevent fire or explosion while testing for a leak:
• ALWAYS perform leak test prior to lighting the grill.
• DO NOT smoke while testing for a leak.
• ALWAYS perform leak tests outdoors in a well-ventilated area.
• DO NOT use any source of flame while testing for leaks.
• DO NOT use the grill until any and all leaks are corrected.
• If you are unable to correct a leak, close the manual shutoff valve and call a gas appliance service
dealer.
Perform Leak Test
• Prepare leak test solution by combining 1 part liquid dish soap with 3 parts water. Total solution
required is approximately 2 - 3 ounces (70 - 90 ml). Put leak test solution in a spray bottle.
• Ensure all control knobs are in the O OFF position.
• Connect the gas hose to the gas supply.
• Open the manual shutoff valve.
• Spray leak test solution on all gas carrying connections and fittings. Presence of bubbles at areas of
applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off the
gas supply valve immediately and repair or replace the defective part. Do not use the grill until all
leaks are corrected.
Use only the hose assembly provided. If a replacement is necessary, please call our customer service
center. DO NOT use replacement parts that are not intended for this grill.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT FIRE,
DAMAGE AND/OR INJURY.
CAUTION
WARNING
18

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dga550ssn-d

Tabla de contenido