Liquid Coolant - Beta Motorcycles RR 125 LC 2019 Manual De Instrucciones

4
1
EN

LIQUID COOLANT

The level check must be performed with
the engine cold, as follows:
- Unscrew cap 1 and ensure that the liquid
is visible in the lower portion of the load-
2
ing tube.
- In the case in which the liquid is not visible
remove the vent screw 2 and proceed
topping up.
- At the end of operation refit the filler cap
and the vent screw.
Use the fluid indicated on page 16 in the
"Recommended lubricants and liquids" table.
WARNING: Never unscrew the
filler cap of the radiator when the
engine is hot. Danger of burning!
WARNING:
Wear appropriate protective cloth-
ing and protection gloves.
Keep coolant out of reach of chil-
dren.
Avoid any direct contact of the cool-
ant with skin, eyes or clothing. If this
happens:
- with the eyes, rinse immediately with
plenty of water and seek medical advice;
- with skin, Immediately clean contaminat-
ed areas with soap and water Change
clothing that is contaminated with cool-
ant.
If coolant is swallowed, contact a doctor
immediately.
42