External Units Power Supply - Promax TV EXPLORER HD+ Manual De Instrucciones

USER'S MANUAL. TV EXPLORER HD+
Sensibility
Video output
SOUND
Input
Outputs
Demodulation
De-emphasis
Subcarrier
USB INTERFACE
DVB-ASI INTERFACE
Type
Connectors
Packets
Transmission
EXTERNAL UNITS POWER
SUPPLY
Terrestrial and Satellite
22 kHz signal
Voltage
Frequency
7
Maximum power
8
DiSEqC GENERATOR
POWER SUPPLY
Internal
Batteries
Autonomy
Recharging time
External
Voltage
Consumption
Auto power off
7
If you select 5V, the maximum power shall not exceed 2.25 W (450 mA).
8 TM
DiSEqC is a trademark of EUTELSAT.
11/2013
1 Vpp (75 Ω) positive video.
Scart (75 Ω).
Scart.
Built in speaker, Scart.
TV PAL, SECAM, NTSC system according to
DVB-T/H, DVB-T2, DVB-C, DVB-S/S2 and MPEG
standards.
50 μs, 75 μs (NTSC).
Digital frequency synthesis according to the TV
standard.
"USB On-the-go" for datalogger and channel plans
transfer.
Mass Storage Host: The equipment can read /
-
write on Flash drives.
Serial Port Emulation.
-
USB CDC: (Communications Device Class).
-
1 DVB-ASI input and 1 DVB-ASI output.
Female BNC, impedance 75 Ω.
Transport Stream of 188 or 204 bytes (automatic
detection).
Packet or burst mode.
Through the RF input connector.
External or 5/13/15/18/24 V.
Selectable in satellite band.
0.65 V ± 0.25 V.
22 kHz ± 4 kHz.
5 W.
According to DiSEqC 1.2 standard.
7.2 V 12 Ah Li-Ion battery.
> 4.5 hours in continuous mode.
3 hours up to 80% (instrument off).
12 V.
40 W.
Programmable. After the selected amount of
minutes without operating
Deactivable.
on any control.
Page 9