Selecting The Operation Mode: Tv / Spectrum Analyser / Measurements; Channel Tuning / Frequency Tuning - Promax TV EXPLORER HD+ Manual De Instrucciones

USER'S MANUAL. TV EXPLORER HD+
5.3 Selecting the Operation Mode: TV / Spectrum Analyser /
Measurements
The TV EXPLORER
Analyser and Measurements. To switch from TV operation mode to the Spectrum
Analyser press [13] key. To switch to the Measurements mode press
In the TV operation mode the demodulated television signal is shown on-screen;
this is the default operation mode, various functions can be selected, as shown in the
following paragraphs.
In the Spectrum Analyser operation mode the screen displays the spectrum of
the active band (terrestrial or satellite). The span and the reference level.
In the Measurement mode the screen shows the available measurements
according to the type of signal selected.
5.4

Channel Tuning / Frequency Tuning

Pressing [24] key the
tuning and back again.
In channel tuning mode turning the rotary selector
channels defined in the active channels table. When turning it clockwise frequency
increases while turning it anticlockwise frequency decreases.
In frequency tuning mode there are two ways of tuning:
1. Turning the rotary selector
Turning the rotary selector
continuous from 5 to 1000 MHz and from 950 to 2150 MHz). When turning it
clockwise frequency increases while turning it anticlockwise frequency
decreases.
2. Using the keyboard.
Press the rotary selector
appear on the upper left corner of screen the keyboard symbol of manual data
entry ), next enter the frequency value in MHz using the numeric
keyboard. The TV EXPLORER
closest to the entered value and then display it on-screen.
11/2013
HD+ has three basic operation modes: TV, Spectrum
switches from frequency tuning to channel
EXPLORER
[1].
[1] selects the desired frequency (tuning is
[1] (the frequency listing will disappear and will
HD+ will calculate the tuneable frequency
[12] key.
[1] sequentially tunes the
Page 31