Bartscher 400M Manual De Instrucciones página 60

Problem
The device does not
create vacuum
in the container
The container or
the lid lose their
vacuum
The problems listed above are used as a guide or example. If these or similar
problems occur, switch the device off immediately and find a solution. Immediately
contact qualified personnel or the manufacturer for inspections and repairs.
- 58 -
Possible cause and solution
Reconnect the suction hose to the container lid (or to the
suction cap, if necessary) and the hose air inlet to the device.
Leave at least 3 cm between the contents and the top of the
container.
Liquid could leak because it did not cool off sufficiently before
being vacuum sealed. Cool the liquid in the refrigerator and
not at room temperature.
Make sure that the top edge of the container and the gasket
of the lid are intact and clean. Clean both with a moist cloth
and perform vacuum packaging.
Make sure that the gaskets of the container lid are positioned
properly and are not damaged.
Make sure that the top edge of the container and the gasket
of the lid are intact and clean. Clean both with a moist cloth
and perform vacuum packaging.
Make sure that the gaskets of the container lid or the
universal lid are positioned properly and are not damaged.
Make sure that the hose is connected properly to the
container lid and to the hose air inlet (4) of the device.