Esquema De Conexiones Eléctricas - 300 - Midea RSJ-16/190 Manual De Usuario Y De Instalación

8.2 – ESQUEMA DE CONEXIONES ELÉCTRICAS - 300
1A/1B/1D/1F wire comes out from tank,must connect with the corresponding component.
The L,N wires,which get
through the zero-phase
electricity mutual inductor,
must keeping the sam
direction during wring,
otherwise, system
malfunction may caused.
Item Content
CAP1 Fan capacity
CN1-40 Terminal base
TR Transformer
1A-1B- Connected wires inside of the tank
1D-1F
CT1 Zero-phase electricity mutual
inductor
CT2 AC mutual inductor
RY1,3 Relay connecting wires
KM1,KM2 Relay
TCO Temperature protective switch
UE Electric heater of the tank
XT1,XT2 Mid terminal base
ATCO Automatic temperature recover
switch
EVV Electric expansive valve
T3 Evaporator temperature sensor
T4 Ambient temperature sensor
T5U Tank temperature sensor (Upper)
T5L Tank temperature sensor (Lower)
TP Discharge temperature sensor
TH Suction temperature sensor
PRO-H High Pressure Protection Switch
26
MAIN CONTROL PANEL
T3: Sensor de T5L: Sensor de temperatura del
temperatura del depósito de almacenamiento
evaporador (inferior)
T4: Sensor de TP: Sensor de temperatura de
temperatura ambiente descarga
T5U: Sensor de TH: Sensor de temperatura de
temperatura del aspiración
depósito de
almacenamiento
(superior)
Wiring diagram of tank
inside
SW1 Model selection(User never allow to alter the factory
settings)
ON
SW1_1 Without Electric Heater With Electric Heater
SW2_2 Without Disinfect With Disinfect
SW2 Model selection(User never allow to alter the factory
settings)
ON
SW2_1 300L model 190L model
SW2_2 Power furquency_60Hz Power furquency_50Hz
OFF
OFF