Troubleshooting - Sony VPL-CS2 Manual De Instrucciones

D:\Data\Oka\407983411VPLCS2CX1WW\02GB-
VPLCS2,CX1WW\07MNT.fm

Troubleshooting

If the projector appears to be operating erratically, try to diagnose and correct the problem
using the following instructions. If the problem persists, consult with qualified Sony personnel.
Power
Symptom
The power is not turned on. • The power has been turned off and on with the I / 1 key at a short
Both the LAMP/COVER
and FAN/TEMP indicators
light up.
Picture
Symptom
No picture.
The picture is noisy.
The picture from INPUT A
connector is colored
strange.
"Please check INPUT-A
setting." appears in spite of
inputting the correct signal
from INPUT A.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
Cause and Remedy
interval.
c Wait for about 90 seconds before turning on the power
(see page 24).
• The lamp cover is detached.
c Close the lamp cover securely (see page 31).
• The air filter cover is detached.
c Close the air filter cover securely (see page 32).
• The electrical system breaks down.
c Consult with qualified Sony personnel.
Cause and Remedy
• Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made
(see page 16).
• The picture is cut off.
c Press the MUTING PIC key to release the muting function
(see page 23).
• Input selection is incorrect.
c Select the input source correctly using the INPUT key
(see page 22).
• The computer signal is not set to output to an external monitor.
c Set the computer signal to output to an external monitor
(see page 16).
• The computer signal is set to output to both the LCD of the
computer and external monitor.
c Set the computer signal to output only to the external monitor
(see page 16).
• Noise may appear on the background depending on the
combination of the numbers of dot input from the connector and
numbers of pixel on the LCD panel.
c Change the desktop pattern on the connected computer.
• Setting for INPUT-A in the SET SETTING menu is incorrect.
c Select RGB or COMPONENT for INPUT-A in the SET
SETTING menu according to the input signal (see page 30).
• Setting for INPUT-A in the SET SETTING menu is incorrect.
c Select RGB or COMPONENT for INPUT-A in the SET
SETTING menu according to the input signal (see page 30).
masterpage:Left
33 GB
Troubleshooting
VPL-CS2/CX1
4-079-834-11 (1)