Avr-A-Opt-03/C Connection; Connection With Auxiliary Coil - WEG AVR-A-OPT-03 Manual De Instalación, Operación Y Mantenimiento

www.weg.net

15 AVR-A-OPT-03/C CONNECTION

15.1 CONNECTION WITH AUXILIARY COIL

GERADOR
GENERADOR
GENERATOR
CAMPO DA EXCITATRIZ
CAMPO DE LA EXCITATRIZ
EXCITER FIELD
EXCITER FIELD
JR JS
Drp U/F Vad Stb
JHz
OK
Exc
JR JS JT
U/F
¹ Item not supplied by WEG (opened – parallel, closed – single);
² If there is no Potentiometer connected, keep terminals
³ 10A/250Vac switch to turn ON/OFF the regulator;
JR, JS e JT Jumpers – Sensing voltage selection (pins 1-2 = 160 to 300Vac, pins 2-3 = 320 to 600Vac).
4
ATTENTION
1. Before connecting the regulator to the generator, verify in the installation manual, the reference
nominal voltage.
2. The sensing voltage can be different than the alternatorphase voltage. Note the point where the
sensing voltage is taken from (middle of the phase or complete phase).
3. If the reference voltage is not equal to the output voltage of the generator, do not make the
connections without consulting the service department.
20
l Analog Voltage Regulator AVR-A-OPT-03
CHAVE LIG./DESL.
ON/OFF
LLAVE LIG./DESL.
SWITCH
ON/OFF SWITCH
BOBINA AUXILIAR
AUXILIARY
BOBINA AUXILIAR
COIL³
AUXILIARY COIL
3 N
F+
AVR-A-OPT-03/C
F-
Configuration for 160 to
320V use jump on pins
4
1 and 2
JT
Sensing Voltage 160 to 300Vac and 320 to 600Vac.
P1 P2
S1 S2
CHAVE SINGELO / PARALELO
LLAVE SINGELO / PARALELO
SINGLE / PARALLEL SWITCH
R S T S1 1 S2 2
WRGA-01/C
JR
Drp
U/F Vad Stb
JHz
JR JS JT
short-circuited;
SINGLE/PARALLEL
SWITCH ¹
POTENCIOMETRO DE AJUSTE
EXTERNO DE TENSÃO (5k EXTERNAL ADJUSTMENT /3W)
POTENTIOMETER
POTENCIOMETRO DE AJUSTE
EXTERNO DE TENSION (5k /3W)
(5k/3W) ¹ ²
EXTERNAL ADJUSTMENT
POTENTIOMETER (5k /3W)
Configuration for 320 to
600V use jumper on pins
4
2 and 3
JS JT