salmson SIRIUX Jr Instalación Y Instrucciones De Puesta En Marcha página 11

ENGLISH
1. GENERAL
1.1 About this document
These installation and operating instructions are an
integral part of the product. They must be kept readily
available at the place where the product is installed.
Strict adherence to these instructions is a precondition
for the proper use and correct operation of the
product.
These installation and operating instructions conform
to the relevant version of the product and the
underlying safety standards valid at the time of going
to press.
2. SAFETY
These instructions contain important information which
must be followed when installing and operating the
pump. It is therefore imperative that they be read by
both the installer and the operator before the pump is
installed or operated.
Both the general safety instructions in this section and
the more specific safety points in the following sections
should be observed.
2.1 Instruction symbols used in this operating manual
Symbols :
General danger symbol.
Hazards from electrical causes.
NOTE: ...
Signal words:
Imminently hazardous situation.
Will result in death or serious injury if not avoided.
WARNING!
Risk of (serious) injury.
"Warning" implies that failure to comply with the safety
instructions is likely to result in (severe) personal injury.
CAUTION!
Risk of damage to the pump/installation. "Caution"
alerts to user to potential product damage due to non-
compliance with the safety instructions.
NOTE:
Useful information on the handling of the product. It
alerts the user to potential difficulties.
2.2 Personnel qualification
The personnel installing the pump must have the
appropriate qualification for this work.
2.3 Risks incurred by failure to comply with the safety
instructions
Failure to comply with the safety precautions could
result in personal injury or damage to the pump or
installation. Failure to comply with the safety
precautions could also invalidate any claim for
damages.
In particular, failure to comply with these safety
instructions could give rise, for example, to the
following risks:
• Failure of important pump or system functions,
• Personal injury due to electrical and mechanical
causes.
2.4 Safety instructions for the operator
The relevant accident precaution regulations must be
observed.
Potential dangers caused by electrical energy must
be excluded. Local or general regulations (e.g. IEC,
etc.) and directives from local energy supply
companies are to be followed.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
2.5 Safety instructions for inspection and assembly
The operator must ensure that all inspection and
assembly work is carried out by authorised and
qualified specialists who have carefully studied these
instructions.
Work on a pump or installation should only be carried
out once the latter has been brought to a standstill.
2.6 Unauthorised modification and manufacture of
spare parts
Changes to the pump/machinery may only be made
in agreement with the manufacturer. The use of
original spare parts and accessories authorised by the
manufacturer will ensure safety. The use of any other
parts may invalidate claims invoking the liability of the
manufacturer for any consequences.
2.7 Improper use
The operating safety of the pump or installation can
only be guaranteed if it is used in accordance with
paragraph 4 of the operating instructions. All values
must neither exceed nor fall below the limit values
given in the catalogue or data sheet.
11