Safety Precautions For The Operator - Wilo Drain STS 80 Serie Instrucciones De Instalación Y Funcionamiento

●
Max. immersion depth:
ATTENTION!
2 Safety
These instructions contain important information which must be followed when installing and
operating the pump. These operating instructions must therefore be read before assembly and
commissioning by the installer and the responsible operator. Both the general safety instructions
in the "Safety precautions" section and those in subsequent sections indicated by danger sym-
bols should be carefully observed.
2.1 Danger symbols used in these operating instructions
Safety precautions in these operating instructions which, if not followed, could cause personal
injury are indicated by the symbol:
when warning of electrical voltage with
The following symbol is used to indicate that by ignoring the relevant safety instructions, dam-
age could be caused to the pump/machinery and its functions:
2.2 Staff training
The personnel installing the pump must have the appropriate qualifications for this work.
2.3 Risks incurred by failure to comply with the safety precautions
Failure to comply with the safety precautions could result in personal injury or damage to the
pump or installation. Failure to comply with the safety precautions could also invalidate any
claims for damages.
In particular, lack of care may lead to problems such as:
Failure of important pump or machinery functions,
Personal injury due to electrical, mechanical and bacteriological causes.
Damage to property.

2.4 Safety precautions for the operator

Existing regulations for the prevention of accidents must be followed.
Dangers caused by electrical energy are to be excluded. Directives issued by the VDE [German
Association of Electrical Engineers] and the local electricity supply companies are to be ob-
served.
All risks of injury due to mechanical and bacteriological causes must be ruled out. The local pro-
visions and regulations governing sewage technology must be observed.
2.5 Safety information for inspection and assembly
The operator must ensure that all inspection and installation work is carried out by authorised
and qualified specialists who have carefully studied these instructions.
20 m
Standard cable length: 10 m
,
ATTENTION!
English
13