Battery Level Display; Recharging The Battery Pack - Stryker AHTO Manual De Utilización Y Mantenimiento

Battery Level Display

The Battery Level Display shows the current level of charge left in the battery
pack.
Display
2 bars
1 top bar
1 solid bar with
scrolling bars
underneath
1 bottom bar,
flashing
Battery Check Button: When the system is unplugged and no cassette is present,
the battery level may be checked by depressing the Battery Check button.

Recharging the Battery Pack

When a red bar is illuminated on the Battery Level Display, the battery pack will
need recharging. To recharge the battery, plug the unit in to an AC outlet. The
Battery Level Display will show the current charge level during charging and will
shine steady when charging is complete (an "FC" will appear in the flow rate
display and no cassette is present). Complete charging takes approximately 1.5
hours.
Note A fully charged battery pack will power approximately 30 cases at the
high flow rate.
When the unit or the AC power cord is not in use, wrap the power cord using the
cord tie in the back of the unit.
Note If the battery pack does not provide at least 15 standard cases (at the
high flow rate), the battery pack needs replacement.
Note If the unit is not being used for a period of time exceeding 2 months,
disconnect the battery pack.
Table 2: Battery Level Display
Current battery level
Batteries fully charged
Unit is charging; Current level shown by solid bar
When bar appears, there is enough charge remaining for one typical case
only
Meaning
11