Publicidad
Idiomas disponibles
Idiomas disponibles
2) Attach the String Cutoff Blade to guard extension
using M5×20 Screw, locking with square nut (on Fig.2)
as shown on Fig. 3 .
3) Enter the guide in the slot of Blade Guard on Fig. 4.
Make sure place the three hooks into the position on
the guard as shown on Fig. 5.
Guard extension
Fig.4
(7) Blade
1) Install the brushcutter blade onto the boss adapter,
then install the clamping washer, stabilizer and blade
bolt.
2) Align the hole in the boss adapter with the guide slot
in the gearcase.
3) Insert theφ3,5mm pin into the hole in the boss
adapter and the guide slot in the gearcase to lock the
attaching shaft.
4) Tighten the blade bolt.
Note: The blade bolt has LEFT-HAND thread.
BEFORE OPERATION
FUEL : MIXING GASOLINE AND OIL
The two-cycle engines used in the Brushcutter requires a mixture of GASOLINE and OIL for lubrication of bearings
and other moving parts. The proper fuel mixture ratio is 25:1, which is 40cc of oil mixed with one liter of gasoline.
NOTE: Gasoline and oil must be premixed in a clean gasoline container, Never mix gasoline and oil indoors or in the
Brushcutter fuel tank. Always use fresh gasoline.
WARNING!!-NEVER USE GASOHOL OR ALCOHOL BLENDED FUELS IN MARUYAMA ENGINES.
Before filling the Brushcutter fuel tank, clean around the fuel tank cap so dirt and debris does not enter the fuel tank.
Always shake the fuel container before filling the tank. Remove the fuel cap, then fill the fuel tank to within about
10mm from the top of the tank. Avoid filling the fuel tank filler neck. Install the cap securely onto the fuel tank.
Blade Guard
Guide
Hook
String Cutoff
Blade
M5×20
Screw
Fig.3
Fig.5
Left-hand
thread
Attaching
Shaft
Boss
Adapter
Gearcase
― US-4 ―
Hook
Blade Bolt
Stabilizer
Washer
Brushcutter
Blade
Holding Tool
(φ3,5mm Pin)
Publicidad
