Publicidad
Idiomas disponibles
Idiomas disponibles
SPARK PLUG
The spark plug should be removed from the engine and checked after
each 25 hours of operation. The tips can be cleaned with a stiff brush.
Adjust the gap to 0.6-0.7 mm. Replace the spark plug if it is oil-fouled
or damaged, the average spark plug life is approximately 100 hours.
COOLING FINS
Free passage of air through the cylinder cooling fins is required to
prevent poor engine performance and shortened engine life.
Regularly check and clean all debris from the cooling fins by removing
the engine cover.
FUEL FILTER
The fuel filter is attached to the fuel pick-up tube inside the fuel tank.
After each 25 hours of use, it should be checked for dirt or damage,
and replaced if necessary. A wire, etc., with a hooked end aid in
removing the filter from the tank. Avoid damaging the fuel line.
LUBRICATION
The gearcase should be checked for lubrication after each 30 hours
of use. Remove the cutting attachment and the boss adapter. Clean
any dirt and debris from the area between the boss adapter and the
gearcase. Remove the grease plug from the side of the gearcase.
While rotating the attaching shaft, inject lithium-base bearing lube
(P/N 211337) through the plug hole until the gearcase is full.
Re-install the gearcase plug.
GENERAL CLEANING AND TIGHTENING
The Brushcutter will provide maximum performance for many, many hours if it is maintained properly.
Good maintenance includes regular checking of all fasteners for correct tightness and cleaning the entire machine.
STORAGE
For long-term storage of the Brushcutter, perform all regular
maintenance procedures and needed repairs. Empty the fuel tank.
Start the engine and allow it to run at idle speed until it stops. Remove
the spark plug and squirt a very small amount of oil into the cylinder.
Pull the starter cord once and bring the piston to the top of the cylinder.
Re-install the spark plug. Store the Brushcutter in a dry place away
from excessive heat, sparks or open flame.
Gearcase
― US-7 ―
Bearing Lube
(P/N.211337)
Grease Plug
Plug Hole
Boss Adapter
Attaching Shaft
Publicidad
