Device elements
1 Fleece filter bag
2 Suction support
3 Suction hose
4 Cable hook
5 Carrying handle
6 Power cord
7 Mains plug holder
8 Storage compartment for hoses
9 Wheel
10 Suction head lock
11 Suction head
12 Steering roller
13 Dirt receptacle
14 Nameplate
15 Pickup for floor nozzle
16 Main switch
17 Switch between hard surface/carpet
18 Floor nozzle
19 Adjustable telescopic suction pipe
20 Upholstery nozzle
21 Heater brush
22 Crevice nozzle
23 Lid lock
24 Cover
25 Telescopic suction pipe
26 Suction force regulator (continuous)
27 Bender
28 Exhaust filter
29 Filter casing
30 Main filter basket
31 Motor protection filter
32 Grid of the motor protection filter
Colour coding
The operating elements for the cleaning
–
process are yellow.
The controls for the maintenance and
–
service are light gray.
The appliance can be operated in 2 ways:
1 Operation with fleece filter bag or paper
filter bag (option)
2 Operation without filter bag
Check whether main filter basket has
been inserted into the appliance.
Installation of the filter bag
Release and remove the suction head.
Remove the main filter basket.
Install the fleece filter bag or the paper
filter bag (option).
Insert main filter basket.
Insert and lock the suction head.
Turning on the Appliance
Plug in the main plug.
Switch on the appliance at the main
switch.
Cleaning operations
Set the selection switch of the floor noz-
zle to hard surface or carpet.
Regulate the suction force on the suc-
tion force regulator (continuous).
Perform the cleaning operation.
Turn off the appliance
Switch off the appliance at the main
switch.
Pull out the mains plug.
After each operation
Empty the container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
– 2
EN
Start up
Operation
7