Hoshizaki KM-280MAH-E Manual De Instalación página 2

ENGLISH
IMPORTANT IMPORTANT IMPORTANT IMPORTANT IMPORTANT
1. In order to carry out safe and proper installa-
tion of the product, please read this booklet
carefully beforehand and follow the instruc-
tions contained within.
2. On completion of the installation, start the
icemaker to check for any abnormalities, and
instruct the user on how to use and maintain
the icemaker in accordance with the Instruc-
tion Manual.
3. This booklet should be handed over to the
user after the installation and be preserved
by the user together with the Instruction
Manual for any further consultation that may
be necessary.
WARNING WARNING WARNING WARNING WARNING
The installation must be carried out by qualified The installation must be carried out by qualified The installation must be carried out by qualified
The installation must be carried out by qualified The installation must be carried out by qualified
personnel, personnel, personnel, personnel, personnel, in accordance with current regulations,
according to the manufacturer's instructions.
1. UNPACKING 1. UNPACKING 1. UNPACKING 1. UNPACKING 1. UNPACKING
WARNING WARNING WARNING WARNING WARNING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
CAUTION CAUTION
CAUTION CAUTION CAUTION
Remove shipping carton, tape(s) and packing. If
packing material is left in the icemaker, it will not
work properly.
Note: This icemaker needs a storage bin. The
recommended storage bin is HOSHIZAKI
ICE STORAGE BIN, Model B-300 series.
1) After removing the packaging, make sure that the
icemaker is in good condition. If in doubt, please
do not use the equipment but apply to professionally
qualified personnel. See the instruction sheet at-
tached to the Storage Bin for its unpacking and
installation guidelines.
2) Remove the panels to prevent damage when install-
ing the icemaker. (See "2. HOW TO REMOVE
PANELS.")
3) Remove the package containing the accessories
from the compressor compartment.
4) Remove the protective plastic film from the panels. If
the icemaker is exposed to the sun or to heat, remove
the film after the icemaker cools.
5) Check that the refrigerant lines do not rub or touch
lines or other surfaces, and that the fan blade turns
freely.
6) Check that the Compressor is snug on all mounting
pads.
7) See the Nameplate on the Rear Panel, and check that
your voltage supplied corresponds with the voltage
specified on the Nameplate.
8) Remove the shipping tapes securing the Cube Guide.
2. HOW TO REMOVE PANELS - See Fig. 1 2. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 1 2. HOW TO REMOVE PANELS - See Fig. 1 2. HOW TO REMOVE PANELS - See Fig. 1
Fig. 1 Fig. 1 Fig. 1
Fig. 1 Fig. 1
a) Top Panel . . . . . . Remove the screw, lift up at
front slightly, push rearward
and lift off.
b) Front Panel . . . . . Remove the screw, lift up
toward you.
c) Side Panel (R) . . . Remove the screw, slide
forward slightly, and lift off.
d) Insulation Panel . . Lift up slightly, and pull
toward you.
e) Base Cover . . . . . Lift up slightly, and pull
toward you.
2
91A1NG11A0105