JENN-AIR ProStyle Manual Del Usuario página 22

{)V:EN ])OO:R
N EVER place excessive weght on or
stand on an open oven door This
:ouUd cause the range to tip over,
break the door. or injure the user.
NEVER attempt to open or close
door or operate oven until door is
" NEVER place fingers between hinge
and front oven frame. Hinge arms are
spring mounted, ifacddentally hit, the
hingewi[[ dam shut againstovenframe
and could injure your fingers.
TO REMOVE:
1. When cook open the oven door to the
broil stop position (opened about four
inches).
2. Grasp door at each side. Do not usethe
door handle to lift door.
3. Lift
up evenly until door dears hinge
arms.
TO REPLACE:
I. Grasp door at each side.
2. Ahgn slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge arms
until the door iscompletdy seatedon the
hinges. Pushdown on the top corners of
the door
to
completely seat door on
hinges.Door should not appearcrooked.
NOTE: The oven door on a new range may
feel"spongy" when it isclosed.This isnormal
and will decrease with use.
OvEN W N >OW
TO PROTECT THE OVEN DOOR
W_NDOW:
m.Do not hit the glass with pots, pans,
furniture, toys, or other objects.
2 Do not close the oven door until the oven
racks are in place.
Scratching, hitting, jarring or stressing the
glass may weaken its structure causing an
increased risk of breakageat a later date.
L:E(::; S
• Besure the anti-tip bracket securesone of
the rear leveling legs to the floor. This
bracket prevents the range from acciden-
tally tipping.
The range should be leveled [_
when installed. If the range is
N'II [lid
not UeveLturn the pUast c UeveU- IIL iil
legs, located ateach jji' jiJ
corner of the /_o .:;'-'-5/
ran [e is level _ _ ANTI-TIP RRACKET
g " {_' LEVELING LEG
REi%' RANGE FO]:{
£LEAN_NG &, SERVICE
1. Shut offgas supply to appliance.
2. Disconnectdectrical supplytoappliance.
3. Disconnect blower system.
4. Disconnect gas supply tubing to appliance.
S. Slide range forward to disengage from
anti-tip bracket. (See Installation Instruc-
tions for location of bracket.)
6. Reverse procedure to reinstall. Ifgas line
has been disconnected, check for gas
leaks after reconnection. NOTE: A
qualified servicer should disconnect
and reconnect gas supply.
7. To prevent accidental tipping, range must
be secured to the floor by sliding rear
leveling leg into anti-tip bracket.
OVEN
To assure the proper replacement bulb is
used_order bulb from Maytag Customer
Sen,ice. Call 1-800-688-840g, ask for part
number 74004458 - halogen bulb.
, Disconnect power to range before re-
placing hght bulb.
before
touching.
TO REPLACE OVEN L_GNT BULB:
1. When oven iscool, usefingertips to grasp
edge of bulb cover. Pull out and remove.
2. Carefully remove old bulb by pulling
straight out of ceramic base.
3. To avoid damaging or decreasing the life
of the new bulb, do not touch the bulb
with bare hands or fingers. Hold with a
cloth or paper towel. Push new bulb
prongs straight into small holes of ce-
ramic base.
4. Replace bulb cover by snapping into place.
S. Reconnect power to the range. Reset
clock.
2m