Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.8.5
Led for K-bus diagnosis.
Led I/O
Off
Red
flashing
Orange
fixed
Green
fixed
3.8.6
Diagnostics display.
During start-up, display shows the current
firmware version for 3 s.
If an error occurs during start-up, this will be
indicated via a flash sequence of the associated led.
Configuration errors are shown in the display via
"TC-Config" and the error number.
Use the System Manager to check hardware
GB
configuration or contact support.
Display
TC-
Config
0xF0nn
3.9.1
K-bus Error codes.
Error
Argu
Code.
ment
0
-
0
1
1
2
2
-
3
0
0
4
n
20
Description
No data is exchanged via the
K-bus.
Error. The type is indicated
in the display.
Register or KS2000 online
access.
K-bus OK and running.
Description
The Bus Terminal n° "nn" does
not
correspond
to
configuration.
Compare
structure of Bus Terminal n°
"nn" with the configuration.
Description
EMC problem
Eeprom checksum error.
Code buffer overflow.
Unknown data type.
Reserved.
K-bus command error
K-bus data error, break
behind the Controller.
Break behind I/O Module
n
Firmware errors are shown in the display via "FW-
Error" and the error number.
Display
FW-Error
0xnnnn
3.9
K-bus diagnostic Error Codes.
To visualize a K-bus Error Code:
−
press for 3 seconds the
Joystick
to
BX3100 setup menu;
−
press the Joystick in Left
or
Right
navigate the setup menu
until reach the K-bus
menu, indicated on BX3100 display;
−
the indication of eventual Error Code is
visualized on display;
−
the meaning of Error Codes and relative
description are indicated in table 3.9.1;
−
to exit the setup menu press for 3 seconds the
Joystick.
the
bus
Check power supply for over voltage or under voltage
peaks. Implement EMC measures.
If a K-bus error is present, it can be localized by a
restart of the controller (by switching it off and then on
again).
Set factory setting with KS2000 configuration
software.
Insert
fewer
I/O
configuration has too many entries in the table.
Update the Bus Terminal Controller Software.
-
No I/O Modules inserted.
One of the I/O Modules is defective; halve the number
of I/O Modules connected and check whether the error
is still present with the remaining I/O Modules.
Repeat until defective I/O Modules is located.
Check whether the n+1 I/O Module is correctly
connected; replace if necessary.
Check the Bus End Terminal KL9010 be connected.
Description
Please contact support.
enter
the
position
to
Solution
Modules.
The
programmed
3.300.185-D
Publicidad
Tabla de contenido
