Extraordinary Maintenance; Control And Security Elements - arilex 40FG70 Manual De Instrucciones

Use warm soapy water on steel surfaces, rinse well and dry with a soft cloth. To main-
tain the shine, clean from time to time with liquid POLISH.
Do not wash the countertop or the floor with muriatic acid.
OIL COLLECTOR TANK
It is necessary to periodically check that the oil level does not reach the edge of the oil
collecting container and that the filter is clean. Empty and clean the filter regularly. The
tray can be easily grasped thanks to a removable handle.

4.2. EXTRAORDINARY MAINTENANCE

Periodically (at least once a year and depending on the frequency with which the devi-
ce is used), submit the device to a complete check, which also includes an examination
of the tightness of the gas circuit, checking the integrity of the
the components and possible greasing of the controls if it is difficult to maneuver them.
Contact a specialized technician who has the necessary professional requirements.
For this it is advisable to stipulate a maintenance contract with a center authorized by
the manufacturing company.
4.3. CONTROL AND SAFETY ELEMENTS
If the device is not used for a long period of time or if it does not work or works irregu-
larly, it is necessary to close the gas stopcock.
All components of the device subject to wear and tear can be easily reached from the
front of the device by opening the door or removing the front panel. All the fittings are
obtained by means of a nut and bicone, so it is necessary to be very careful when
handling these components; If they are damaged during the disassembly and / or
assembly phases, the component must be replaced.
with a new one.
In the event that the oil temperature exceeds the set values, the safety thermostat
breaks the thermocouple contact. To start the device again, open the door and press
the red button.
Be careful, because the activation of the safety thermostat may indicate a defect in
the gas valve or the thermostat; Before restarting the device, an authorized technician
must replace the defective component.
31