Parking Brake Function; Cruise Control Operation; Hourmeter; Volt Power Outlet - Simplicity Regent Serie Manual Del Operador

Features & Controls

Parking Brake Function

Applying the Parking Brake - See Figure 2. To lock the
parking brake, release the ground speed pedals (A), fully
depress the brake pedal (B), pull UP on the parking brake knob
(C), and then release brake pedal.
Releasing the Parking Brake - See Figure 2. To release the
parking brake, depress the brake pedal (B).

Cruise Control Operation

TO ENGAGE:
1. Pull up on the cruise control knob (D, Figure 2).
2. Depress the forward ground speed pedal (A).
3. Lift up the Cruise control knob (D) when desired speed is
reached. The Cruise will lock in one of its five locking
positions.
TO DISENGAGE:
1. Depress the brake pedal (B, Figure 2).
OR
2. Depress the forward ground speed pedal (A).

Hourmeter

(Select Models)
The hourmeter (E, Figure 2) measures the number of hours the
key has been in the RUN position.

12 Volt Power Outlet

CAUTION
Avoid Injury. Safe operation requires your full
attention. Do not wear radio or music
headphones while operating machine.
The 12-volt accessory plug is located in the left side pod (F,
Figure 2). It can be used to power small electronic devices. The
accessory must be rated at 9 amps or less.
NOTE: Operating a 12-volt accessory, especially with the
engine at idle, may cause battery discharge. When not
using the accessory plug it must be covered with the
rubber plug to prevent moisture from causing a short
circuit. Entrance of water into plug can cause a
short circuit.
(Select Models)
B
C
F
Figure 2. Engaging the Parking Brake
A. Ground Speed Pedals
B. Brake Pedal
C. Parking Brake Knob
D. Cruise Control Knob
E. Hourmeter
F. 12V Power Adapter
14
E
A
D