Safety Instructions; Basic Information Concerning Safety - Hilti POS 15 Manual De Instrucciones

Battery life (with distance / angle measurement every
30 seconds)
Weight
Dimensions
POA 81 AC adapter and POA 82 charger
AC supply
en
AC frequency
Rated current input
Rated voltage
Weight (POA 81 AC adapter)
Weight (POA 82 charger)
Dimensions (POA 81 AC adapter)
Dimensions (POA 82 charger)
Temperature
Operating temperature range
Storage temperature range
Dimensions and weights
Dimensions
Weight

4 Safety instructions

4.1 Basic information concerning safety

In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
4.2 Misuse
The tool and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when
used not as directed.
a) Never use the tool without having received the ap-
propriate instruction on its use or without having
read these operating instructions.
b) Never point the tool or its accessories toward
yourself or other persons.
c) The connecting cable between the PC and the
POS 15/18 must be clearly visible and positioned so
that it presents no hazard.
d) Do not render safety devices ineffective and do
not remove information and warning notices.
e) When switching distance measurement from prism
measurement to reflectorless measurement, make
sure that you do not look at the objective lens of the
tool.
f) Have the tool repaired only at a Hilti Service Center.
Failure to follow the correct procedures when
16
16 h
0.1 kg (0.2 lbs)
67 mm x 39 mm x 25 mm (2.6" x 1.5" x 1.0")
100...240 V
47...63 Hz
4 A
5 V
0.25 kg (0.6 lbs)
0.06 kg (0.1 lbs)
108 mm x 65 mm x 40 mm (4.3" x 2.6" x 0.1")
100 mm x 57 mm x 37 mm (4.0" x 2.2" x 1.5")
-20...+50°C (-4°F to +122°F)
-30...+70°C (-22°F to +158°F)
149 mm x 145 mm x 306 mm (5.9" x 5.7" x 12")
4.0 kg (8.8 lbs)
opening the tool may cause emission of laser
radiation in excess of class 3R.
g) Modification of the power tool or tampering with its
parts is not permissible.
h) The grip is designed to have a certain amount of play
at one side. This is not a fault. It serves to protect
the alidade. Tightening the screws on the grip may
cause damage to the thread, making costly repairs
necessary. Do not tighten any screws on the grip!
i) To avoid the risk of injury, use only genuine Hilti
accessories and additional equipment.
j) Use only clean, soft cloths for cleaning. If necessary,
they may be moistened with a little alcohol.
k) Keep laser tools out of reach of children.
l) Measurements to plastic foam surfaces, e.g. poly-
styrene foam, to snow or to highly reflective surfaces,
may result in incorrect readings.
m) Measurements taken to surfaces with low reflectivity
in highly reflective surroundings may be inaccurate.
n) Measurements taken through panes of glass or other
objects may be inaccurate.
o) The measurement may be incorrect if the conditions
under which the measurement is taken change rap-
idly, e.g. due to people walking through the path of
the laser beam.
p) Do not point the tool toward the sun or other powerful
light sources.