Tabla De Contenido - Grundfos Unilift AP12 Instrucciones De Instalación Y Funcionamiento

English (US) Installation and operating instructions
Original installation and operating
instructions
These installation and operating instructions
describe Grundfos Unilift AP12, AP35 and
AP50.
Sections 1-5 give the information necessary to
be able to unpack, install and start up the
product in a safe way.
Sections 6-10 give important information about
the product, as well as information on service,
fault finding and disposal of the product.
CONTENTS
1. Limited warranty
2. General information
2.1 Symbols used in this document
2.2 Overview drawing
3. Receiving the product
3.1 Inspecting the product
3.2 Scope of delivery
4. Installing the product
4.1 Pipe connection
4.2 Minimum space
4.3 Location
4.4 Adjustment of cable length for float
switch
4.5 Electrical connection
5. Starting up the product
5.1 Starting
6. Product introduction
6.1 Applications
6.2 Identification
6.3 Functions
6.4 Pump construction
7. Servicing the product
7.1 Cleaning the pump
7.2 Contaminated pumps
7.3 Replacement of parts
8. Fault finding the product
9. Technical data
9.1 Operating conditions
9.2 Sound pressure level
9.3 Storage
10. Disposing of the product
4
Prior to installation, read this
document. Installation and operation
must comply with local regulations
and accepted codes of good practice.
Successful operation depends on
careful attention to the procedures
described in this manual. Keep this
manual for future use.
Page
5
5
5
6
6
6
6
6
7
7
7
8
8
9
9
10
10
12
12
12
13
14
14
14
15
16
16
16
16
16