Blodgett SG2136 Manual De Instrucciones página 13

CONVEYOR BELT DIRECTION
Conveyor travel is factory set for either left to right or
right to left belt operation as ordered. If the opposite
direction is required, the polarity of the drive motor
must be reversed as follows and the conveyor belt
must be removed, reversed and reinstalled or the
belt will be damaged. Refer to page 13 for belt in-
stallation instructions.
Blower 1
Heat
Relay
Circulation Blowers'
Pressure Switch
Blower 2
Relay
Relay
Interface Board
To reverse polarity:
1. With the oven cold, DISCONNECT THE
POWER CORD TO THE OVEN. Unscrew the
electrical box access cover.
2. Flip the dipswitch marked DIR1 on SW4 (switch
4) on the interface board. See Figure 6.
NOTE: The interface board is located on the
upper rear surface of the electrical box.
Switch 4
(See View A)
Figure 6
11
Installation
Oven Assembly
View A
SW4
ENB 2
DIR 2
ENB 1
DIR 1