Maintenance
Troubleshooting Guide
POSSIBLE CAUSE(S)
SYMPTOM: Burner will not fire (SG2136G) or elements will not heat (SG2136E).
Control turned off.
S
Temperature set point not above the ambient
S
temperature.
Convection blower motor(s) not running.
S
Display: BLOWER FAULT --- CALL SERVICE
Fuse(s) are blown.
S
Emergency stop button is pushed in (remote
S
control oven only).
For SG2136G ovens only
Manual gas valve closed.
S
Combustion blower motor not running.
S
Display: COMBUSTION BLWR FAIL --- CALL
SERVICE
Combustion blower pressure switch defective or
S
not set properly.
Display: COMB PS FAULT --- CALL SERVICE
Burner did not ignite properly or flame ceased.
S
Display: IGNITION ALARM --- PRESS RESET
or NO FLAME SENSE --- RESET OR CALL SERVICE
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is
recommended, however, that All repairs and/or adjustments be done by your local Blodgett service
agency and not by the owner/operator. Blodgett cannot assume responsibility for damage as a result
of servicing done by unqualified personnel.
SUGGESTED REMEDY
Press ON/OFF key.
S
Set to the desired temperature. See page 24 of
S
the Operation section for instructions.
*
S
Unplug the oven power cord and check the fuses
S
(SG2136E). Call service if necessary.
Pull the button out to disengage the emergency
S
stop.
Open valve.
S
*
S
*
S
Press the reset button on the electrical box
S
control tray, located to the left of the LED
indicator lights. Call service if necessary.
32