Storage - Gravely Promaster 34Z Manual Del Operador

Adjust Blade Height
Level and pitch the mower with the height adjusters on each
deck lift bracket (Figure 22).
Loosen the jam nut on the deck lift bracket bolt about
1/4 turn to reduce clamp load on the height adjusters.
Loosen the jam nut on the deck adjuster bolt and then
turn the bolt clockwise to raise the deck or
counterclockwise to lower the deck. Tighten both jam
nuts.
Height Adjusters
DO NOT place blocks under reinforcement bar.
Figure 22
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
SHORT TERM
NEVER spray unit with high-pressure water or store unit
outdoors.
Inspect unit for visible signs of wear, breakage or damage.
Keep all nuts, bolts and screws properly tightened and know unit
is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure water and
lubricate (See Lubricate Unit on page 14 in Maintenance). Touch
up all scratched painted surfaces.
Remove weight from wheels by putting blocks under frame or
axle.
When storing unit for extended periods of time, remove all fuel
from tank and carburetor (run dry). Refer to Engine Manual.
Clean and charge the battery. Charge battery every three to four
weeks when storing unit.
To Take the Unit Out of Storage
1. Refer to the engine service manual to prepare the engine
for service.
2. Put fresh, clean fuel in the fuel tank.
3. Begin the maintenance schedule.
4. Charge and install the battery.
GB-20

STORAGE