Oster FPSTJE900 Serie Manual De Instrucciones página 19

Before First Use
Before your begin, remove any packaging material and extra stickers/ labels from your juicer. Check that
the unit is turned off and unplugged.
Wash all of the components with warm/soapy water before assembling: the filter basket,
cutting disc, food pusher, pulp collector and juice jug and lid. Rinse and dry thoroughly.
Motor can be wiped down with a damp cloth. Your juicer is now ready for use.
1
• Place filter basket on top of
the motor housing.
4
• Raise the safety locking
arm up and then lower it
down to securely fit into the
grooves (from right to left)
on the lid. The arm should
rest vertically on top of the
juicer lid – keeping in in
place.
7
IMPORTANT: Remember to place the juice nozzle/drip stopper open and facing down before
juicing.
FPSTJE9000 Series_19SEM1 (LA).indd 5
ASSEMBLING YOUR JUICER
2
• Place the Rinse n' Ready™
filter on top of the filter
basket, push down and
click into place.
5
• Slide the food pusher down
the food chute. Be sure
to align the grooves in
the pusher with the small
protrusion on the inside
top of the feed chute. Push
all the way down until it's
entirely within the chute.
• Place the juice jug with lid under the spout located on the right
hand side of the juicer. Use the juice jug lid to avoid any splatter.
Alternatively, you can fit the juice nozzle over the juice spout and
place a glass underneath. This will direct the flow of juice directly
into the glass to ensure mess-free juicing! You can flip the juice
nozzle/drip stopper up to avoid dripping on the countertop.
En glish-5
3
• Place juicer cover/lid on
top of the filter basket.
6
• Place the Pulp Collector
into position by tilting it
slightly at an angle to
fit underneath the juicer
cover. Important: Check
that the Pulp Collector
edge is underneath the lip
of the basket.
3/7/19 08:52