Oster FPSTJE900 Serie Manual De Instrucciones página 20

1. Wash your fruits and vegetables thoroughly before juicing.
Root veggies should be double-checked to ensure all of the soil is removed
to avoid getting grit in your yummy juice.
2. At this point, your juicer should be assembled properly and ready for use. Refer back to the assembly
instructions if this is not the case. Always place the juice jug (or a glass) underneath the spout and
check that the pulp collector is in position before you begin. If you forget, there's a good chance your
juice will end up on your countertop!
3. Plug unit in. Make sure the knob is on the OFF position. Raise the safety locking arm up to the lid.
Note: the lights only turn on when you select a speed.
4. Turn the control knob to the RIGHT to your desired speed (from 1 to 5 for model 9020 or Low or High
for model 9010). The juicer will immediately start to operate at the selected speed indicated on the
speed dial. Speed can be changed at any time during the juicing process by adjusting the control
knob.
Models
with
2 speeds
5. As the motor is running, begin placing food into the feed chute and use the food pusher to guide food
down into the machine. For maximum extraction, slow controlled pushing of the food pusher down the
chute is ideal.
6. As fruit and veggies are processed, you'll start to see juice will flowing into the juice jug.
Simultaneously, the separated pulp will accumulate in the pulp collector. The pulp collector can be
emptied during the juicing process by turning the juicer control knob to the OFF position and then
carefully removing the pulp collector to clean. Replace the empty pulp collector back into position and
get right back to juicing.
WARNING
Never use fingers, hands or utensils to push food down the chute.
It is important to ONLY use the food pusher to avoid injury.
FPSTJE9000 Series_19SEM1 (LA).indd 6
TO BEGIN JUICING
Models
with 5
speeds
Eng lish -6
3/7/19 08:52