DHC BT2100 Manual De Usuario página 10

Press the ◄ ► key to select battery rating
5.
CCA/SAE, EN, IEC or DIN. Press «ENTER» to
confirm choice.
Press the ◄ ► key to input the battery capacity
6.
• SAE (CCA) 25~3,000
• EN 25~2,830
• DIN 25~1,685
• IEC 25~1,985
• JIS Battery Type No.
Press «ENTER» to begin the test.
Press the ◄ ► key to confirm the location of
7.
the battery if a surface charge is detected,
follow the tester 's instruction to remove the
surface charge.
8. Testing battery.
9. Aim the "Temperature Measurement sensor"
2.5cm (1 inch) from the top or sides of the
battery case and press <<ENETR>>. Measured
temperature may vary by distance from the battery, under hood
conditions, and cabinet temperature.
10. When the test is completed, the display shows the results as
following. {Press the◄ ► key to select: Temperature, SOH
(STATE OF HEALTH), and SOC (STATE OF CHARGE)}.
GOOD & PASS
3
- -
9