Machine Dimensions - SKF TKSA 20 Manual De Instrucciones

3.6 Machine dimensions

The configuration of the machinery is defined by three dimensions.
A: The distance between the two measuring units, as measured between the fixture
centre marks.
B: The distance between the M-marked measuring unit and the front pair of feet of the
Movable machine.
C: The distance between the front feet and the rear feet of the Movable machine.
Fig. 14. Machine dimensions
a) Measure the A, B and C distances. The default
values for these three distances are:
A = 200 mm (8 in)
B = 200 mm (8 in)
C = 400 mm (15 in)
b) Adjust each value by using the + and - buttons.
c) Confirm the setting of each value by pressing
the "next" button.
Note!
If you need to go back and change
values already entered use the "previous"
button.
SKF TKSA 20
Fig. 15. Distances A, B and C
15