Verify Alignment - SKF TKSA 20 Manual De Instrucciones

The F1 and F2 values indicated on the display give
the relative positions of the Movable machine when
viewed from above (fig. 25). The F1 value for the front
pair of feet, the F2 value is for the rear pair of feet.
The alignment values indicate the necessary corrective
sideways movement of the Movable machine (when
viewed from behind the Movable machine).
A negative value means that the feet have to be
moved to the right. A positive value means that the
feet have to be moved to the left (fig. 26).
Observe the coupling and feet values live adjustment
while moving the movable machine sideways and
compare them with the values in table 1.
The alignment is complete. Tighten the feet of the
movable machine.

3.9 Verify alignment

To verify the alignment of the machinery, it is recommended to execute the measuring
procedure once again. To do so, go back by using the previous button until you reach the
first measuring step (9 o'clock position) and continue as per chapter 3.7.
20
Fig. 25. Display horizontal alignment
Fig. 26. Horizontal alignment
SKF TKSA 20