Installing Breakers; Installing Cord Sets - Tripp-Lite SUDC208V42P Serie Manual Del Propietário

6. Wiring Installation
WARNING!
Before wiring make sure that all breakers (including the Distribution Center's Main Breaker) are in the
OFF position and that the 3-phase power source is de-energized!

6.2 Installing Breakers

1
Open the Distribution Center's front door to access
the breaker box.
2
Remove 6 screws from the breaker box front panel,
A
then remove the panel and set it aside.
3
Decide which pole position to use for each of your
required breakers and snap each breaker into place.
4
Remove the corresponding panel knockouts from the
breaker box front panel.
Note: Properly label your breakers in the spaces
provided to better manage your electrical system
(labels not included). You may also want to
differentiate labeling between different racks
and cord sets.

6.3 Installing Cord Sets

1
Pass the cord set through one of the cable access channels
in the roof of the Distribution Center, ROJ section first. The
channel you choose depends on your cord set configuration.
2
Select a knockout in the breaker box and remove the insert
for that knockout. The knockout you choose depends on
your cord set configuration.
Note: There are (24) ¾-inch knockouts and (29) ½-inch
knockouts distributed throughout the breaker box.
3
Remove the coupling nut of the strain relief connector from
the cord set.
4
Insert the ROJ section of the cord set through the knockout
and into the breaker box. (Pull the ROJ section through
the knockout until the threaded end of the strain relief
connector is inside the breaker box.)
5
Insert the ROJ section of the cord set through the coupling
nut of the strain relief connector.
6
Attach the coupling nut to the strain relief connector and
tighten, securing the cord set to the breaker box.
Output
Breaker
Breaker Box Interior
AC Connector Cord
11
A
Breaker Box Front Panel
Coupling Nut
Cord Set
Coupling Nut
Strain Relief
ROJ Section
Connector