Wiring Breakers - Tripp-Lite SUDC208V42P Serie Manual Del Propietário

6. Wiring Installation
7 After attaching your cord sets, route and attach these
power cables to your equipment racks.
• Install the optional SRCABLELADDER, SRCABLETRAY
and SRCABLETRAYEXP onto your racks for easier cable
routing and management.
• Starting with the cord sets for the racks farthest away
from the Distribution Center, run each cable to your racks
utilizing your configuration's cable management system.
• Connect the appropriate cord set to the appropriate
PDU, either inside your rack (through one of the cable
access holes in the roof) or on top of your rack's roof
inside the cable management tray.
6.4 Wiring the Breakers
DANGER! LETHAL HIGH VOLTAGE HAZARD!
All wiring must be performed by a qualified, certified electrician in accordance with the warnings
in this manual and all applicable electrical and safety codes. Incorrect wiring may cause serious
personal injury and property damage.
Confirm that the main breaker is OFF before connecting any wiring.
1 Connect the ROJ section of each cord set to the appropriate
breaker, neutral and ground, as appropriate. Leave circuit breakers
in the OFF position until all wiring to load circuits is complete.
Cord Sets Connected to 120V Circuits (L5-20R Connectors):
2
• Connect green wire to the ground bar.
• Connect white wire to the neutral bar.
• Connect black wire to the 1-pole circuit breaker for that circuit
(make sure the cord connector and 1-pole circuit breaker are
labelled accordingly).
Cord Sets Connected to 208V Circuits (L6-30R Connectors):
3
• Connect green wire to the ground bar.
• Connect black wire to 1 pole of the 2-pole circuit breaker for
that circuit.
• Connect white wire to the 2nd pole of the 2-pole circuit breaker
for that circuit.
Connect to
Your PDU
GROUND BAR
12
From
Distribution
From PDU
Center
NEUTRAL BAR