Features - Tripp-Lite SUDC208V42P Serie Manual Del Propietário

4. Features

42-Pole Circuit Breaker Panel: Output branch circuit breakers (sold separately) snap into this panel. The output cord
A
sets (sold separately) will be wired here. Warning: Use Tripp Lite breakers and cord sets only.
Main Circuit Breaker: The 3-phase power source will be wired to this breaker.
B
C Ground Bar: Ground connections will be wired to this bar.
Neutral Bar: Neutral connections will be wired to this bar.
D
Wiring Knockouts: There are (24) ¾-inch knockouts and (29) ½-inch knockouts distributed throughout the breaker box.
E
(Not all knockouts are shown in the diagram. The top and bottom panels of the breaker box also contain knockouts.)
Removable Side Panel: If the Distribution Center is installed on a concrete floor, the wiring from the 3-phase power
F
source can be routed through the appropriate knockout in the removable side panel. You can install the side panel in the
lower position on either side of the Distribution Center to accommodate the placement of the 3-phase power source.
E
Breaker Box Front Panel
E
Breaker
Note: The distance from the
Box Side
front frame of the Distribution
Center (door open) to the back
of the breaker box is 9 inches.
E
5" to
Roof
C
37" to
Floor
34" to
Floor
Distribution Center Front
(Shown without front door)
A
D
2.5"
B
1.88"
2.25"
E
5
F
2.25"
38"
Removable Side Panel
1.88"