Ground Connection - Tripp-Lite SUDC208V42P Serie Manual Del Propietário

5. Cabinet Installation
3
After lowering each leveler, use the carpenter's level to confirm that the
Distribution Center is level in all directions. Adjust the levelers as required until
the Distribution Center is level.
4
(Optional) If you wish to provide an additional measure of stability, you
can attach the 2 shipping brackets, using the hardware that attached the
Distribution Center to the shipping pallet. Use a 13 mm open-end wrench
to connect the brackets to the outer
of the Distribution Center. Attach the brackets to secure mounting points in
the floor using user-supplied hardware or Tripp Lite's Bolt-Down Kit (Part #
SRBOLTDOWN).

5.5 Ground Connection

All the parts of the Distribution Center are grounded to the frame of the enclosure.
Use the Distribution Center's front or rear threaded grounding point
M6 screw (included) to connect the frame of the Distribution Center directly to
your facility's earth ground connection with an 8 AWG wire. Route the ground
wire under the Distribution Center's frame to ensure unhindered door operation.
WARNING: Attach the Distribution Center to earth ground separately—not
daisy-chained with other equipment. Do not use the Distribution Center
without an earth ground connection.
or inner bracket mounting points
A B
8
3
A
4
and an
A
B
A
EARTH
GROUND