Peavey CS 800x4 Manual Del Usuario página 7

4
CS 800
®
x
Power Amplifier
Congratulations on your purchase of a Peavey CS Series power amplifier! Designed for years of reliable operation, CS Series
amplifiers offer the sonic superiority and unsurpassed reliability for which Peavey is famous in a rugged, compact unit.
Advanced technologies and extensive protection circuitry allow operation with greater efficiency, even under difficult loads
and power conditions. The DDT
ohms, protects speakers and ensures sonic integrity even in extreme overload conditions. Peavey's high-efficiency design uses
tunnel-cooled heat sinks and dual-speed DC fans for consistent lower overall operating temperature, resulting in longer output
transistor life.
Peavey CS Series amplifiers are simple to operate and housed in ultra-strong steel chassis, but improper use can be
dangerous. Some CS Series amplifiers are very high powered and can put out high voltages and sizable currents at frequencies
up to 30 kHz. Always use safe operating techniques with these amplifiers.
FOR YOUR SAFETY, READ THE IMPORTANT PRECAUTIONS SECTION, AS WELL AS INPUT, OUTPUT AND POWER
CONNECTION SECTIONS.
Unpacking
Upon unpacking, inspect the amplifier. If you find any damage, notify your supplier immediately. Only the consignee
(the supplier from whom you purchased the amplifier) may institute a claim with the carrier for damage incurred
during shipping. Be sure to save the carton and all packing materials. Should you ever need to ship the unit back to
Peavey or one of its offices, service centers or the supplier, use only the original factory packing. If the shipping carton
is unavailable, contact Peavey to obtain a replacement.
Mounting
CS Series amplifiers will mount in standard 19" racks. Rear mounting ears are also provided for additional support,
which is recommended in non-permanent installations like mobile or touring sound systems. Because of the cables
and connectors on the rear panel, a right angle or offset screwdriver or hex key will make it easier to fasten the rear
mounting ears to the rails.
Cooling Requirements
4 amplifier uses a forced-air cooling system to maintain a low, consistent operating temperature. Air is drawn
CS 800
x
into the amplifier by a fan on the back panel and courses through the cooling fins of the tunnel-configured channel
heat sink, then exhausts through the front panel grille. If the heat sink gets too hot, sensing circuits will open the
output relays for the hot channels, disconnecting the load for those channels. It is important to have an air inlet at the
back of the amplifier to allow cooling air to enter. If the amp is rack mounted, do not use doors or covers on the back
of the rack, as the intake air must flow without resistance. Make sure that there is one (1) standard rack space opening
for every three mounted power amplifiers.
ENGLISH
™
(Distortion Detection Technique) circuit ensures trouble-free operation into loads as low as 2
7