EB TECHNOLOGY Nologo START-S7LT Manual De Instrucciones página 32

START-S7lT
4.5 Connection of the POWER SUPPLy and BATTERy
The following control board can be
1 2 3 4
powered 12/24Vac/dc. To set up
the power supply put the jumper
12V as shown:
12 Vac/dc
Power Supply
4.6 Connection of the MOTOR
Pay attention not invert the poles oPen and CloSe.
In case of doubts out manually the gate in the middle of the stroke.Keep ready
to stop the gate with a SToP CoMMAnde.
Interrupt the photocells if you want to check the correct open, if the gate starts
closing , the connection is wrong and you need to invert the cables oPen with
CloSe of the motor.
4.7 Connection of the ENCODER
19 20 21
4.8 Connection of the LAMPS
5 6 7 8
24 Vac/dc
- power supply of the ENCODER
Signal for encoder
+ 5V power supply of the ENCODER
9 10 11 12 13
!
Use the correct cable to connect the
battery and respect the polarity. DON'T
CONNECT DIRECTLy THE BATTERy.
As the cable has a charge circuit, fuse
and diode of power suplly. WARNING:
The control unit has an emergency
module, connect the battery to the
emergency module as shown in the
scheme.
!
14 15 16 17 18
Connection
of the LAMP
-8-
1 2
For a correct use of the encoder,
we recommend to ready the man-
ual.
!
It is possible to activate or
deactivate the flashing light
for the output of the Light
during the memorization of
the working time Par. 7.2
In case you activate the pre-
lighting see Par. 5.1
operating guide
4
3
MOTOR