EB TECHNOLOGY Nologo START-S7LT Manual De Instrucciones página 44

START-S7lT
7.3 Use the input CLOSE for PARTIAL OPENING
In case you need to use the input CloSe for PARTIAl oPenInG, make as follow:
1
4
1 2 3 4 5 6 7 8 9
2
3
4
5
6
7
8
1 2 3 4 5 6 7 8 9
7.4 Go back to the INPUT CLOSE for CLOSE FUNCTION
1
4
2 3 4 6 7 8 10
5 9
2
3
4
5
6
2 3 4 6 7 8 10
5 9
Take the power supply and put DIP9 in ON.
10
Give power supply to the control unit. (led l1 is
turned off when the control board is programming)
Press the CloSe command (everything connected
to input 16 or the 2nd channel of the compatible
remote control that has been learned)
Press the CloSe command to stop the automation
at the desired point (end of partial opening).
let the time elapse during which the automation
must remain open.
Press CloSe command to start closing
wait for the automation to stop automatically
Put in OFF the DIP9 to return in the standard
function. The signal light turned off and led l1 will
starts again.
10
Take the power supply and put DIP9 in ON.
Give power supply to the control unit.
(led l1 is turned off when the control board is programming)
Press and hold the CloSe command (everything connected to input 16 or the 2nd
channel of the compatible remote control that has been learned)
wait until the led1 starts blinking (about 5 seconds)
Release the button CloSe
Put in OFF the DIP9 to return in the standard function. The signal light turned off and
led l1 will starts again.
-20-
operating guide
The gate is
CloSed
The gate is
oPenInG
The gate is
oPenInG
The gate is
SlowInG down
This is the
automation
"PAUSE TIME"
The automation
starts in
CloSInG mode
The gate is
CloSed
end of the
memorization of the
working time