Description Of The Electrical Connections; Checking Connections - EB TECHNOLOGY Nologo START-S7LT Manual De Instrucciones

START-S7lT
4.3

Description of the electrical connections

12/24 Vac/dc
Motor
- 12/24 Vdc
+ 12/24 Vdc
i.c. lamp
contact for elec.
lock / signal light
Stop 11
Photo Cl 12
olS 13
ClS 14
Start 15
Close 16
Common 17
+ Antena 18
+ 5 Vdc 19
Sgn encoder 20
- 5 Vdc 21
4.4

Checking connections

The LED L1 indicate the correct logic of the control board. It fl ashes each second and it indicates
that the micro-chip is activated and it is waiting for a command.
when the control board is powered, the led are lit on when the input is a closed contact.
normally the red led STOP - PHOTO - OLS - CLS are lit on
normally the green led in in the START - CLOSE are switched off
1
Input for low tension: set up the JUMPeR J12
2
3
output for the connection of the MoToR
4
5
output for the connection of the accessories: Absorption max 1.6 A
6
7
Isolated contact for lAMP
8
9
Isolated contact for eleC. loCK or SIGnAl lIGHT
10
Ingresso SToP
Input photocell PHoTo: operating only when closing
Input for open limit Switch
Input for Close limit Switch
Input for START command: set up dIP 1 and dIP2
Input CloSe command
Common, services and securities
Positive pole antena
Power supply of the encoder
encoder signal
Power supply of the encoder
STOP PHOTO OLS CLS START
-7-
!
We remind you that in
case some inputs are not
used, (STOP, FOTO) you
need to be deactivated
with DIPB as shown in the
Par 5.2
CLOSE
operating guide