EB TECHNOLOGY Nologo START-S7LT Manual De Instrucciones página 43

START-S7lT
7.2 Memorization of the working time with a command START
IF yOU DON'T USE AN ENCODER:
Memorize the time with the trimmers (speed)
1
1 2 3 4 5 6 7 8 9 10
2
3
4
5A
5B
6
7
9
10
11
1 2 3 4 5 6 7 8 9
Take the power supply and put DIP9 in ON.
Give power supply to the control unit.
Press the START button (all which is connected to the terminal
board no.15 or in the 1st channel of the remote control)
Press START to definy when the automation starts slowing
down otherwise read the next passage.
If the open limit switch is not available, when the gate reach the
stroke, press the START comand.
If the open limit switch is connected, you don't need to do
nothing as the limit switch boost the programm.
let the time goes until the gate is opening.
The automation is in PAUSe TIMe
Press START when the gate starts to slowing down, otherwise
you need to read the next passage.
wait until the gate stops automatically.
Put in OFF the DIP9 to return in the standard function. The
signal light turned off and led l1 will starts again.
10
-19-
operating guide
The gate is
CloSed
The gate is
oPenInG
The gate is
SlowInG
down
The gate
SToPS
This is the
automation
"PAUSE TIME"
The automation
starts in
CloSInG mode
The gate is
SlowInG
down
The gate is
CloSed
end of the
memorization of
the working time