Adjusting The Footrest; Optional Angle Adjustable Footplate - Ki Mobility Rogue Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
N. Adjusting the Footrest
Height adjustment of your footrest (Fig.17):
1. Locate the set screw on each side of the frame (Fig. 17:A).
2. Loosen the set screw on each side of the frame using an
M3 Allen wrench. Do not remove.
3. Adjust footrest tube up or down to achieve the desired
height (Fig. 17:B).
4. Ensure both sides are adjusted equally.
5. Retighten each set screw to 40 in./lbs.
O. Optional Angle Adjustable Footplate
To adjust the angle of the optional angle adjustable footplates:
1. Loosen, but do not remove, the two M6 screws securing the footplate to the footplate
clamp with a 4mm Allen wrench.
2. Once loose, the footplate will easily rotate around the footrest extension tube.
3. Select the desired position and retighten the two M6 screws to 80 in./lbs.
Changing position of the optional aluminum flip-up footplate:
1. Remove both M6 screws from the footplate. There are M6 nylock nuts recessed on the
underside of the clamp. Be sure to prevent these from falling as you loosen the screws.
2. Relocate the footplate once the screws are loose by rotating either forward or rearward,
depending on desired angle. Once position is achieved reinsert the screws into the
appropriate holes.
3. Fit the nuts into the slot underneath the clamp and tighten the screws securely.
Fig. 18
26
Fig. 17
B
A