Troubleshooting - Worx WG720 Instrucciones De Seguridad

TROUBLE SHOOTING
PROBLEM
1. Mower doesn't run when
operation bail is activated.
2. Motor stops while
mowing.
3. Mower runs but
cutting performance is
unsatisfactory, or does not
cut entire lawn.
4. Mower is too hard to
push.
5. Mower is abnormally
noisy and vibrates.
14
6. Mower not picking up
clippings with the Grass
Collection Bag.
7. When mulching there are
clippings visible.
12AMP Electric Lawn Mower
Release switch lever to turn mower off. Remove safety key, turn mower
over and check that blade is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
A. Release switch lever to turn mower off. Remove safety key, turn mower
over and check that blade is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Avoid overloading the mower. Slow down the cutting pace by pushing
mower slower or raise the cut height. Or both.
A. Release operating bail to turn mower off. Turn mower over and check:
Blade for sharpness - Keep blade sharp. Deck and discharge chute for
clogging.
B. Wheel height adjustment may be set too low for grass condition. Raise
cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each wheel for
free rotation.
A. Release operating bail to turn mower off. Turn mower on side and check
blade to ensure it has not been bent or damaged. If blade is damaged,
replace with a replacement blade. If the underside of the deck is damaged
return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates:
Release switch lever to turn mower off, remove blade. Rotate blade 180
degrees and retighten. If mower still vibrates, return the mower to an
authorized service center.
A. Remove mulch plate when bagging.
B. Chute clogged. Release operating bail to turn mower off. Clear chute of
grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of
the cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten length of
the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
SOLUTION
EN