Check The Installation - Vetus SENSORD Manual De Manejo Y Instrucciones De Instalación

3.2.5 Subsidiary instrument
Connect a subsidiary instrument directly
to the main instrument or to the network of
sensors, see Chapters 6 and 7.
Use a patch cable*) for this.
*) Patch cable: A Cat.5 UTP network ca-
ble with an RJ45 plug at both ends. Do
not use a 'crossed' cable!
The following lengths of patch cable can
be supplied.
- 3 metres:
Art. code: SENSOR03
- 5 metres:
Art. code: SENSOR05
- 10 metres:
Art. code: SENSOR10
These cables are supplied inclusive with
(1) coupling block.
Ultrasonic tank management system

3.2.6 Check the installation

After making the connections check that
all sensors function.
• Switch on the instrument, see 2.1
'Switching on'.
The volume in the 2 tanks will now be
displayed on the instrument.
• Press the key 1x.
The name of the tank should now be
displayed for each tank connected.
Configuration menu
Tank
Vetus
Display settings
Exit
• Return to the normal display screen as
follows:
Press successively:
, and
• Now set the required language, see
'Setting the language'.
ENGLISH
Vetus
.
37
090430.01