Setting A Security Code; Unlocking A Security Code; Re-Locking Security; Setting Security Back To 0 (Zero) - No Security - Leroy-Somer Digidrive SK Serie Guía De Usuario

Français
5.6.1

Setting a security code

• Set Pr 10 to L2.
• Set Pr 25 to the desired security code e.g. 5
• Set Pr 10 to LoC.
• Press the
• Pr 10 will now be reset to L1 and Pr 25 will be reset to 0.
• The security code will now be locked into the drive.
• Security will also be set if the drive is powered down after a security code has been
set into Pr 25.
5.6.2

Unlocking a security code

• Select parameter to be edited
• Press the
• Press the
will show 'Co'
• Enter the correct security code
• Press the
• If the correct security code had been entered, the right hand display will flash and
can now be adjusted.
• If the security code has been entered incorrectly, the left hand display will flash the
parameter number. The above procedure should be followed again.
5.6.3

Re-locking security

When a security code has been unlocked and the required parameter changes made, to
re-lock the same security code:
• Set Pr 10 to LoC
• Press the
5.6.4

Setting security back to 0 (zero) - no security

• Set Pr 10 to L2
• Go to Pr 25
• Unlock security as described above.
• Set Pr 25 to 0
• Press the
If a security code has been lost or forgotten, please contact LEROY-SOMER.
NOTE
5.7

Setting drive back to default values

• Set Pr 10 to L2
• Set Pr 29 to EUR and press the
parameters.
or
• Set Pr 29 to USA and press the
parameters.
Digidrive SK Getting Started Guide
Issue Number: a
English Deutsch
MODE key
M
MODE key, the right hand display will flash 'CODE'
M
UP key to start entering the set security code. The left hand display
MODE key
M
MODE key
M
MODE key.
M
Italiano
MODE key. This loads 50Hz default
M
MODE key. This loads 60Hz default
M
Español
65