Using the Bath Fill Func on
Filling the Tub
1. Press the "Bath Fill" bu on once.
The bu on will illuminate, and a
Bath Fill
tone will sound.
2. The voice prompt will announce
"The hot water system is ready.
Open the hot water tap."
ON!
COLD
Make sure the water volume is set.
Refer to "Se ng the Water
Volume".
HOT
Open the hot water tap. The "In
Use" indicator will illuminate on
the J‐C200 controllers. The hot
water will begin to flow.
3. When the preset volume of water
ON!
COLD
has been produced then
•
•
HOT
•
•
4. Turn off the bath hot water tap
and push the Bath Fill bu on. The
water heater will not allow hot
Bath Fill
water to flow from any source
un l the "Bath Fill" bu on is
pushed.
The bu on light will go out.
To stop the water flow during the Bath Fill
NOTICE
func on, press the "Bath Fill" bu on. The
To Stop
bu on will flash and the voice prompt will
the Bath
announce, "Hot water is not available.
Fill
Turn off all hot water taps and push the
Before it
Bath Fill bu on." Follow the voice
prompt instruc ons.
Finishes
the water flow will cease
the "Bath Fill" bu on will
flash
a tone will sound
the voice prompt will
announce, "Bath fill is
complete. Turn off the bath
hot water tap and push the
Bath Fill bu on."
Jacuzzi Signature Water Heaters J‐S180/J‐S199
During the bath fill func on, any hot
NOTICE
water flowing at other loca ons,
subtracts from the total amount of water
When
for the bath. For example if the bath fill
Other
func on is set for 50 gallons and 5 gallons
Taps Are
of hot water are used at other loca ons
Open
during the fill period then the bath will
only fill with 45 gallons.
Diagnos c Codes
This water heater is designed with diagnos c codes to
help you determine poten al opera on concerns .
To Display Diagnos c Informa on
To display the most recent diagnos c codes press and
hold the "Power" bu on for 2 seconds on the J‐C100
controller. While holding the "Power" bu on press
the up (+) bu on. The last 9 diagnos c codes will
flash one a er the other. To exit this mode press the
"Power" and up (+) bu on as before.
To enter or exit the maintenance monitor informa on
mode press and hold the down (‐) bu on for 2
seconds and without releasing it press the Power
bu on.
To obtain the water flow rate press the up (+) or
down (‐) bu ons un l "01" displays. The water flow
rate will then appear. For example "58" means 5.8
gal/min.
To obtain the outgoing water temperature press the
up (+) or down (‐) bu ons un l "02" displays. The
temperature will appear in degrees Fahrenheit.
No.
Data
01
Water flow rate
02
Outgoing water
temperature
Unit
0.1 gal/min
Degrees
Fahrenheit
33