Installa On Instruc Ons - Jacuzzi J-SN180F Manual De Instalación Y Funcionamiento

Installer Qualifica ons
A licensed professional should install the appliance,
inspect it, and leak test it before use. The warranty
will be voided due to improper installa on.
The installer should have skills such as:
•
gas sizing
•
connec ng gas lines, water lines, valves,
electricity,
•
knowledge of applicable na onal, state, and
local codes.
•
installing ven ng through a wall or roof
If you lack these skills contact a licensed professional.
Type of Installa on
•
For installa on in residen al and commercial
applica ons.
•
Cer fied for installa on in manufactured (mobile)
homes.
Installa on Steps
Prepare for Installa on ...................................... 5
Determine Installa on Loca on ........................ 6
Checklist to Determine Installa on Loca on . .. 1 2
Mount to Wall . ................................................. 1 2
Remove the Front Panel .................................. 1 2
Installa on of Ven ng (Indoor models) . .......... 1 3
Condensate (Indoor models) ........................... 1 5
Checklist for Ven ng and Condensate
(Indoor models) ............................................... 1 5
Installa on of Plumbing ................................... 1 6
Checklist for Plumbing ..................................... 1 8
Installa on of Gas Supply ................................ 1 8
Connect Electricity ........................................... 2 0
Adjust for High Al tude ................................... 2 0
Adjust for Vent Length . .................................... 2 0
Checklist for Gas and Electricity . ...................... 2 0
Installa on of Temperature Controller . ........... 2 1
Final Checklist .................................................. 2 2
4

Installa on Instruc ons

Jacuzzi Signature Water Heaters J-S180/J-S199
General Instruc ons
DO NOT
•
Do not install the J-SN180F, J-SP180F, J-SN199F, or
J-SP199F outdoors.
•
Do not install the J-SN180W, J-SP180W, J-SN199W,
or J-SP199W indoors.
•
Do not install the appliance in an area where water
leakage of the unit or connec ons will result in
damage to the area adjacent to the appliance or to
lower floors of the structure. When such loca ons
cannot be avoided, it is recommended that a
suitable drain pan, adequately drained, be installed
under the appliance. The pan must not restrict
combus on air flow.
•
Do not obstruct the flow of combus on and
ven la on air. Combus on air shall not be
supplied from occupied spaces.
•
Do not use this appliance in an applica on such as
a pool or spa heater that uses chemically treated
water . (This appliance is suitable for filling large or
whirlpool spa tubs with potable water.)
•
Do not use subs tute parts that are not authorized
for this appliance.
MUST DO
•
The installa on must conform with local codes or,
in the absence of local codes, with the Na onal
Fuel Gas Code, ANSI Z223.1/NFPA 54. If installed in
a manufactured home, the installa on must
conform with the Manufactured Home
Construc on and Safety Standard, Title 24 CFR,
Part 3280.
•
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the Na onal Electrical
Code, ANSI/NFPA 70.
•
The appliance and its appliance main gas valve
must be disconnected from the gas supply piping
system during any pressure tes ng of that system
at test pressures in excess of 1/2 psi (3.5 kPa)
(13.84 in W.C.).