To Replace The Rear Working Lights; To Replace The Warning Lights; To Replace The Taillights; To Do A Check Of The Parking Brake - Husqvarna P 520D Manual De Usuario

To replace the rear working lights

1. Disconnect the cables from the broken lamp.
2. Remove the screw on the connector.
3. Remove the lamp connector with the lamp attached.
4. Attach the new lamp connector. Refer to
data on page 142 .
5. Connect the cables to the new lamp.

To replace the taillights

1. Disconnect the cables from the broken lamp.
2. Remove the 2 screws on the connector.
3. Remove the lamp connector with the lamp attached.
4. Attach the new lamp connector. Refer to
data on page 142 .
5. Connect the cables to the new lamp.
128

To replace the warning lights

1. Disconnect the cables from the broken lamp.
2. Remove the screw on the connector.
3. Remove the lamp connector with the lamp attached.
Technical
4. Attach the new lamp connector. Refer to
data on page 142 .
5. Connect the cables to the new lamp.

To do a check of the parking brake

1. Park the product on a hard surface that slopes.
Note: Do not park the product on a grass slope
when you do a check of the parking brake.
2. Push the parking brake forward.
Technical
3. If the product starts to move, let an approved service
agent adjust the parking brake.
4. Pull the parking brake rearward to release the
parking brake.
To do a check of the parallelism of
the cutting deck
1. Do a check of the air pressure in the tires. Refer to
Tire pressure on page 132 .
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
Technical
740 - 002 -